Wheel Moves

                                     

wpe26.jpg (7472 bytes) BOSS WHEEL MOVES (a.k.a. Side Rolls or Lateral Rolls) are repositioned by a hydraulic power mover (HPM). The BOSS HPM is constructed of heavy gauge steel and high quality components. Recent design changes and modifications make the BOSS HPM one of the strongest and safest units available. The BOSS HPM leaves the factory pre-assembled with the hydraulic hoses, filters and orbit motors in place to help reduce set-up time in the field.
wpe20.jpg (3956 bytes) Every piece of high quality aluminum torque tube is hydrostatically tested, and is available in 4" or 5" diameters.
wpe21.jpg (6970 bytes) Strong galvanized hub wheels are available in different sizes to allow various crop clearance.
wpe22.jpg (6573 bytes) It is easy to clean any trash, debris or sand with the flushing end plug - standard on BOSS systems.
wpe23.jpg (6096 bytes) Special flexible hose is used for the end feed - center feed is also available.

wpe25.jpg (5546 bytes)

STANDARD ON ALL BOSS WHEEL MOVES

  • Hydraulic Power Mover
  • 8 H.P. gasoline engine
  • Engine Cover with Hardware
  • Axles - 4"or 5" diameter steel
  • 2050 x 12’ Chains
  • 8 hole x 20’ - flanged axles
  • Gear Coupler Torque Pipe
  • O’rings
  • Mushroom Drains & Clips
  • Torque Clamps
  • O’Ring Gear Coupler End Feed
  • O’Ring Gear Flushing End Plug
  • 4" x 20’ Hose with Male Ends and Band & Latch
  • 1" x 90° x ¾" Riser Elbows
  • ¾ " Counterbalances
  • Sprinklers (Rain Bird®, Nelson®, Senninger® etc.)
  • Wind Braces
  • 5’, 7’, or 8’ Diameter Wheels incl.
    Hubs, Spokes, Half Rims, Cleats 3/8" x 1" Bolts & 3/8" Nuts