) |
B202 1/2 inch full circle impact sprinkler with a 7 degree angle of trajectory. Works best with a 7/64 nozzle at approximately 25 - 30 PSI. |
SPRINKLERS
|
|
B202 1/2 inch full circle impact sprinkler with a 7 degree angle of trajectory. Works best with a 7/64 nozzle at approximately 25 - 30 PSI. |
| B202N 1/2 inch full circle impact sprinkler with a 27 degree angle of trajectory. Works best with a 9/64 nozzle at approx 25 - 30 PSI. |
) |
) |
B303 3/4 inch full circle brass impact sprinkler with a 27 degree angle of trajectory. Suggested range nozzle sizes: 9/64, 5/32, 11/64, 3/16. For the opposite side we recommend the 1/8 spreader or a plug. Sprinkler will operate over a wide range of pressures but we suggest an operating pressure between 30 - 45 PSI. |
| B303-PC 3/4 inch part circle brass impact sprinkler with a 27 degree angle of trajectory. Also has a spreader nozzle, see suggested nozzle sizes and pressures for B303. |
) |
) |
B303-LA 3/4 inch full circle brass impact sprinkler with a 10 degree angle of trajectory. Uses 2 nozzles but we recommend using a plug on the spreader side. The range nozzles are the same as the B303 and the suggested operating pressure is 30 - 45 PSI. |
| B404 3/4 inch full circle brass impact sprinkler with a 33 degree angle of trajectory. This sprinkler is larger than the B303 and is designed for a higher operating pressure and the application of larger volumes of water. We recommend using a 7/32 or 1/4 range nozzle with a 1/8 spreader. Suggested operating pressure is 50 - 60 PSI. This sprinkler is good on side rolls if you have enough water and pressure. |
) |
) |
B707 1 inch full circle brass impact sprinkler. A variety of range and spreader nozzles are available and the suggested operating pressure is 55 - 75 PSI. |
|
|
|
| (Note: BOSS Irrigation is committed to continuous improvement. Small, but positive changes are often made with each production run. In most cases the product is made better and the cost to our customers is held constant. The item(s) shown above are for illustration purposes, and the product shown could be from an earlier production run or it could be the prototype for an upcoming production run. The exact item(s) pictured may or may not be in our current inventory. For example: air relief valve set screw changed from steel to stainless steel, counter balance paint changed to epoxy coating, and sand cast couplers are moving to permanent molds and pressure die casting. Quantities are limited to amount in inventory, and prices are subject to change without notice. Please contact your BOSS sales person for current pricing and the latest product improvements. Our goal is to give you value – the best quality products at the most affordable prices.) | |